Asomodai

Could be many things other than hop rubber. Does it happen when the hop is set to minimum? If so it could be hammer the gas system as well 

PM your address and I’ll post it . If its of use to you just mail back the M4 one

JG G36. Relatively lightweight, but sturdy plastic with foldable stock. The Stock catch doesn't break if you look at it wrong. Very simple internals. Rugged.

If you cant be bothered to buy something specific, use any sort of deodorant like Lynx and it should break up the sticker residue and use a plastic implement to remove the gunk. I have been doing it for years. (No the smell does not linger on plastic!)

Have you contacted the seller?

The TM MK23 mags have emergency release gaskets if the gas used is higher pressure then green gas. You need to seal those puppy's up to use anything more powerful.

The TM MK23 mags have emergency release gaskets if the gas used is higher pressure then green gas. You need to seal those puppy's up to use anything more powerful.

To handle it? Seal the magazine gaskets so you can use red gas and install a long inner barrel. 

I was on the fence about buying anything this year. But realised I really needed to buy a Black Tac vest as I only have a tan chest rig at the moment. (Need more body protection!) 
 
I already knew they had 15% off, saw they had this gorgeous looking Pentagon Apsis Vest. I had to have it! 
 
Grabbed a few other bits like Grey Hat, Balaclava and a black Dump Pouch. 

@Cr0-Magnon Has joined the FN-57 Master Race. Welcome good sir and get a nice Guarder kit on it whilst you are there! Feels really nice on mine! 

@Cr0-Magnon
 
I got a Guarder Outer Barrel and made the Hop unit "ear" cuts that Maple Leaf did to theirs to prevent wear. I also drilled out the business end of the outer barrel as it was a little bit too small and caused BB's to hit the edge. 

@Cr0-Magnon Has joined the FN-57 Master Race. Welcome good sir and get a nice Guarder kit on it whilst you are there! Feels really nice on mine! 

@Tactical Pith Helmet Getting to Tuddenham on Public Transport from Dagenham has always been a no go! I have been before, it's not bad at all. But not worth the ballache. 
 
@colinjallen I decided against it this weekend. I just did a 17 Mile hike around the North Downs and Lower Weald. I may go Airsoft tomorrow, haven't decided! 

And just like that one of the lips on a Cyma AK74 Hicap just tore off. Of course I can't get anything reasonably priced in Rip off Britain! Got these for 4 quid each before. Cheapest I can find it is 13 now.

@Floperator I very much appreciate the offer. But with some of the closures on the underground I think i'll have to give it a miss. If I do play it may be out Essex way. 

It is a crying shame. No motor in the Airsoft world performs as well working backwards as they do forwards. 

@strykerles
 
Quite possibly. But they are just bits of metal after all. 
 
I have turned over a new more fiscal leaf and value paying off my credit card more then the rifles. Hence the competitive prices! 

I do like my AK's these days and having so many rifles and not enough time to use any of them is just... depressing. 

Welcome to the RS T97/B Club! I have a pair myself

@Cr0-Magnon figured as much. Sites have been fully booked up very quickly since the heatwave started. Hit us up if you end up going to Absolute. 5AM start for me to get to Al's for 7AM!

Both Albiscuit and I will be at Absolute Airsoft in Reading on Sunday. There are spaces left for pre booking I think.
 
Almost no sites do walk-ins at the moment due to Covid.

Mine has had both the Cree bulb installed (And a resistor to hold the power back a bit as it runs hot and will melt the ABS housing.) I also have a tighter lens installed.
 
It's quite dazzling now. 

@Steveocee Jakub at Perun has sorted me out. Sending me a replacement after showing him a few photographs. He and the others at Perun seem quite disturbed as to what happened as they haven't seen it happen before with the ETU!

I was already a big fan of Perun before. (I am credited with turning Luke at Negative onto them when I sent in my XM8 with one to fit). But even more so now! 
 
 

@Steveocee Jakub at Perun has sorted me out. Sending me a replacement after showing him a few photographs. He and the others at Perun seem quite disturbed as to what happened as they haven't seen it happen before with the ETU!

I was already a big fan of Perun before. (I am credited with turning Luke at Negative onto them when I sent in my XM8 with one to fit). But even more so now! 
 
 

I am a fairly avid player. Bought it on full release and have put in nearly 300 hours. You can find me on EXD and RIP servers mostly.