Asomodai

It's for use when I have the stock folded

Hello gents. Looking for an appraisal on the following. Dytac SLR AK74 - 336FPS on .20 ZCI 433mm Inner Barrel Guarder Clear Hop Rubber and Prommy Purple nub SHS 14 ½ piston G&G brass Cylinder Head G&G V3 Gearbox G&G Bushings SLD Piston Head S&T Aluminium Full Cylinder Lct Hop unit Perun Mosfet Sorbo SHS High Torque 16TPA Neodymium Motor. ZCI Advanced 18:1 gearset. Comes with the original box, no mag, but works fine with every mag I have tried, Midcap, HiCap, different brands etc. Comes with the Foregrips as on the photos. Currently has a CYMA Railed Dust cover installed, but will include the original Dytac Dust cover and rear sight. The Receiver is made of stamped Steel. The Bolts in the stock have been replaced with thicker German bolts which are much more sturdy then the suspect stock ones. This is a quiet sounding well shimmed AK. I can provide a firing video if required. I reckon I have used this AK maybe 4 or 5 times at a skirmish and is in good external condition.

I find that with a-lot of the short type SHS/Rocket motors. I have had to cut down the motor pinion a few mm. Had to do it on both my Real sword T97's

A friend of mine with more experience in such matters reckons it's for a closed bolt WE GBBR.

Lots of quality complaints recently. Shattering and under the microscope looks like a moonscape.

Sites are always welcome to comment and have done so before.

Site Name: Apocalypse Paintball and Airsoft Contact details: 01763 244855 Website Address: Apocalypse Paintball Facebook Page: Apocalypse Airsoft & Paintball | Facebook Site Address: Old N Rd, Royston SG8 5JS Desperate for a Bank Holiday Monday game and Driver Wood being a little too far for @Albiscuit we decided to go give Apocalypse Paintball and Airsoft a visit. This used to be run by RIFT Airsoft and was better known as "The Village". Not much has been written about the site since Apocalypse took back control to run the airsoft side themselves, so we were going in pretty much blind. Apocalypse Airsoft is a very small Woodland site located south of Cambridge. It is rectangular shape with a small tail where the Safe Zone and Playing Area entrance is. There is a Tower/Church Area, Village, Fort and Tyre section. All can be seen from the centre of the site. There are many buildings, only the Fort and Tower have an extra story. Only the tower has a roof. There are lots of very tall trees and lots of extra low foliage along with barricades to help create cover. The site is very flat with no real elevation. Short/Medium/Long engagement distances are in play. There were around 30+ players on the day. This site requires* the use of Bio BB's. No bangs are allowed as the site next to a Psychiatric hospital. Smoke only. Good: Chrono: A mandatory chrono was in affect and result was noted against your registered name though no guns were marked. AEG FPS limits are a 350FPS. DMR is 450 and Bolt actions are 500. Green Gas blowback pistols are not chronoed in the Winter. Safe Zone: Is a fairly small safe zone which can cater for about 50-60 players. Picnic benches that were all under cover. The Shop and confectionary stands were all inside. It was a pretty nice safe zone. Protected from the elements. Toilets were just by the entrance. Parking: A gravel track running up to the safe zone. So no long walks. Average: Clientele: The Vast majority of the clientele were experienced Airsofters. Very few rentals. Everyone appeared to be over 18 and well into their 30's. The people we spoke to were quite friendly but kept to themselves within the safe zone. People did talk to each other during the gameplay though. Game modes: We only played two game modes before going home. The first one was a small push back and flag waving game onto the Tower from the Village. Second was a more elaborate and interesting game trying to get ammo crates and box to a fort. Toilets: Two Portaloo's, they were in OK condition. Value: £25 for a skirmish, food not included. Bang average. Bad: Playing area: On paper, the playing area appears to be very well equipped and should play quite well, but on the day it just didn't work out. The site is just too open. There are plenty of low barricades, but not enough medium height vegetation. You can see from one end of the site to the other almost anywhere you stand. As a result it's very hard to push up on objectives without good team work and luck. The site is full auto almost all of the time and is detrimental to the playing area environment. It feels very much like just another paintball site that does Airsoft. The fort and village area is covered by stinging plants and I came away with lots of welts trying to crawl up to the objective without getting shot. It was almost perverse! There were trenches on parts of the site, but they were so shallow and surrounded by stinging plants that they were difficult to flank people in. Safety Brief: Very short, didn't cover MED for snipers (Which resulted in a bad incident where someone left early). Delivered very flat. Catered towards experienced players rather then the rentals that may have needed more instruction. Marshalling: Either Lackadaisical or non existent. One Head Marshal and two player Marshals. The Head Marshal seemed to not care that much. The player Marshals were no where to be seen; The one our side seemed determined to carry out the objective, but often went off and did his own solo thing without rallying the side together. He was never around to report things to. Complaints of non hit taking were at best not followed up or at worse laughed off. Food: Almost non existent. Sweets, Crisps and Drink. No hot foot available on site. The website mentions you can pre order food beforehand but I saw no real mechanism for this. Shop: Bio BB's and gas were for sale and precious little else. Bio only BB: I have no issue with sites being Bio only, both myself and @Albiscuit bought our BB's from the shop before playing and they were of reasonable quality. However there were ZERO spot checks as to whether people were actually using Bio BB's. The player next to use was openly using non bio bb's as can be seen from his bottle. No point in having a very staunch and visible rule if you don't plan on checking up on it and enforcing it. Turn Around Time: We didn't get many games in at all. Safety Brief was supposed to happen at 9:30AM, but didn't until gone 10. We were given a 5 minute warning to reload and get back out but waited over 20 minutes before anything happened. Hit Taking: Flipping awful. Shooting long range and see bb's pinging off of people? Good luck, because softer hits seem to be completely ignored by almost everyone. Try shooting at people running full pelt and see the BB's pinging off? Guaranteed they wont take it. Shooting someone point blank and expect them to take it? Nah, they will just bring their rifle around and shoot you in response and claim it was 50/50. The day has some of the most blatant non hit taking I have seen in Airsoft. It got so bad that we left early (I have only ever done this once before at an Airsoft Skirmish and it was @Albiscuit first time leaving early ever). Many other people were complaining about hit taking which got progressively worse as the day went on and we were certainly not the only people to leave early due to it. It was just pointless trying to carry on. The Marshal's either weren't around to complain to, or did nothing when we did. One kid was getting so frustrated he told me he was going to put in a 420 FPS spring in his Full Auto enabled rifle for the next game. Mentioned it to a Marshal who just laughed it off. Conclusion: This was the worst Airsoft Skirmish I have been to since Tactical Airsoft in Croydon 4-5 years ago. Which had almost identical issues. Hit taking is optional. Full Auto required to get anywhere and non existent Marshalling. Considering how experienced the clientele seemed to be I was surprised how bad it was (I played Ultimate Wargames in Kent two days previous to this visit where 90% of players were under the age of 18 and took almost all their hits and are an absolute credit to the hobby!). It's a real shame how it turned out. The Playing area looks good on paper but the layout just doesn't seem to work. It could be improved upon by increasing the quantity and quality of the barriers. The Stinging nettles could be cut back. The trenches need to be re-dug to be deeper. Full auto should be banned to help have a better chance at pushing up. The marshals need to be more pro-active in stamping out hit taking. So yeah... Not great! There are far better sites that you can go to. Bullpup Watch: L85 and a Tavor.

Bumping this as I popped back down here again on 30/04/22. The playing area has been expanded to a nicely sized CQB section in amongst some bluebell woodland. It is separate to the rest of the site and its an excellent area. Lots of man made props. It's completely worth going to play at! I have edited the review above.

It'll be fine. The UKARA Number is valid for the usual year. I was told that my home site hadn't renewed their insurance when I was buying a pistol at a retailer. It won't invalidate your UKARA. Just means you won't be able to renew after the year is up if the site hasn't been able to get insurance.

I guess I could consider myself a veteran now after 5 years of playing... I still prefer using HiCaps. Yes they rattle, but you are usually making just as much noise just by running around then the rattling of the high caps. When sneaking I have never had a problem with High Caps rattling to the point it gave away my position. High Caps means having to carry less mags which is always a bonus.

That's odd. Mine came with no size differential and mine fits my 62/63cm noggin with plenty of room to spare despite the largest size on the site saying 61cm. I stand corrected. I have found this Ops Core helmet that will fit a 63cm head. Ops Core Green Od Fg Swat Tactical Maritime Abs Helmet Jump Rail L/Xl (lonex.co.uk)

FMA Airframes are all the same size.

Cant have been looking that hard! A quick google search brings up my suggestion as in stock. FMA AirFrame Style Helmet – Dark Earth | Coldbore Airsoft FMA AirFrame Style Helmet | Great Quality | 3 Colours (socomtactical.net)

Myself and a bunch of others will be booking into this as it's my birthday weekend, Not sure whether we'll be Scavs or Bears at the moment.

They are so new to market it's hard to say whether the stock Sears will last long with an upgraded spring. My betting is that it won't. These aren't designed for Sniper FPS out of the box. Not even sure what trigger box or Sears you could use to replace the the stock ones or if they are proprietary. There are certainly no original spare parts available at the moment.

Hello all. I have finally managed to get a set of Swiss M83 Alpenflage in my size. However I have no idea what Chest Rigs/Tactical Vests they used! The M70 Alpenflage had load carrying pockets that you held the mags in. However M83 had no such ability. Anyone have a deep insight into what sort of rigs they used for M83? Searching for Swiss Army Tactical Vests just come up with "Swiss Arms" Tactical vest, the cheap rebadging equipment manufacturer. Cheers! R

Apart from the M249 AFAIK A&K do not produce spare externals for sale. I have emailed and messages them directly multiple times and they never contact back. I was looking for a new MK43 Outer barrel assembly for years.

Of course they went for the one that closest resembles an M4. Yet it's 10/20% heavier then the rifle it replaces. Aesthetically I didn't like any of the three rifles, Though it would have been cool to the GD with Plastic ammo.

UNCompany are one of the oldest Airsoft Companies in existence. However they are also a company who wont get with the times and have a decent website. They are a very trusted name though. Bank Transfer will be fine.

That is an old school G&G Mp5 SD GARS Handguard. They are expensive and no longer made. However the Gunshop in Lille France has one. GG KIT MP5 SD GARS - Gunshop (gunshoplille.com) You'll need to convert the front end of the RIF to an MP5 SD, So new cocking tube, Front Sight, Cocking Handle, Handguard holder and G&G Rail covers. It will require some technical skill and some tools to mate the G3 receiver to the SD front end. ::GTapex.com:: Tokyo Marui G3/MC-51 to MC-51SD (aka the G3 SBS) conversion guide

French Daguet Warm Weather Cap. My Légion étrangère loadout is nearly complete. And second time lucky "Hopefully" a pair of Swiss M83 that will fit me.