Dan_uk86

Few items wanted

6 posts in this topic

Im looking for a nice 4x30/40 scope to fit on to a m4 carry handle rail. interested in red dots if any are going.

also im looking for a silencer that will fit a SRC m4a1 CCW (i think)

 

looking to increase accuracy and i think i may need new hop up unit but any advice on this will be helpful.

have noticed the piston is not completely air tight and would like some parts to improve this

 

leave me some offers below or feel free to pm

 

cheers :)

Share this post


Link to post
Share on other sites

I have a nice 3-9x32 scope without mounts if you're interested. Came with the W700 from AirsoftWorld so it is good quality. It has had its lenses cleaned recently, leaving a tiny speck on the crosshair which is visible while looking down it. It doesn't effect performance. Looking for around £25.

Share this post


Link to post
Share on other sites
I have a nice 3-9x32 scope without mounts if you're interested. Came with the W700 from AirsoftWorld so it is good quality. It has had its lenses cleaned recently, leaving a tiny speck on the crosshair which is visible while looking down it. It doesn't effect performance. Looking for around £25.

 

For the amount i would need to pay for a scope i may aswell save up some pennies and actually buy a sniper with scope :) but ty for the offer.

 

I am still interested in buying some upgrades for my m4.

 

I have had my gearbox apart recently to give it a better grease up and i noticed when i put my finger on the nozzle and pushed the piston in the cylnder i wasnt getting very good air compression.

any recommendations appreciated :)

Share this post


Link to post
Share on other sites

i've got a systema hop unit for £25 posted and paypalled if you're interested

 

had about 1000 rounds through it, then split the gun into bits that it was inside

 

interested?

Share this post


Link to post
Share on other sites

Will keep you posted bud.

bit steep for me at the moment, i may just need a new hop rubber and washers to keep one of the gears in place as one of those are missing.

Share this post


Link to post
Share on other sites
For the amount i would need to pay for a scope i may aswell save up some pennies and actually buy a sniper with scope :) but ty for the offer.

 

I am still interested in buying some upgrades for my m4.

 

I have had my gearbox apart recently to give it a better grease up and i noticed when i put my finger on the nozzle and pushed the piston in the cylnder i wasnt getting very good air compression.

any recommendations appreciated :)

 

Get a pack of O-rings from halfords or somewhere similar, they'll have a slightly thicker one than you'll have in there and it should sort out that issue, after fitting it to the piston just apply a bit of grease (can be teflon or white lithium grease) to a tissue and spread it evenly on the inside of your cylinder to help the piston move freely.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.