Jump to content

RIS Riser help


Albiscuit
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

I have a magnifier and eotech but they do not line up properly. The magnifier has built in adjustment but only to make it taller and it currently sits about 5 - 10mm too high to line up properly with the sight.

 

Struggling to find and doubt I will a RIS Riser with such a small increase. Most seem 25mm, while this may work if I then adjust the magnifier upwards I would rather find the lowest profile one possible.

 

Any ideas on options or other tricks I could use, or should I just reorder a new magnifier?

 

Link to comment
Share on other sites

spent ages looking around, but only looked for RIS Riser :rolleyes:

 

didnt think the obvious

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...