Avid0
Members-
Posts
11 -
Joined
-
Last visited
-
Feedback
0%
Profile Information
-
Guns
TM MP5A4
TM TACMASTER
TM STEYR
KWC GLOCK 26c -
Sites
Combat south
Ucap airsoft
The mall -
Gender
Male
-
Location
South coast
Avid0's Achievements
-
I think the lipo is going to be the next investment, and I made 2 posts as I realised the help and advice section after already posting this and didn't know how to delete this thread
-
Fuse definitely not gone, it half cycles then stops, have to remove the stock, plug in battery direct and it then has enough to fire a round.
-
I can definitely see why not to mess with marui, been a freaking nightmare. What can you recommend for a motor ? SHS or the eg1000 marui, Thanks for the input, much appreciated!
-
I think this is what I am going to have to do, just confused as to why it works fine without the fuse, unless its zapping some power to get through.
-
Right my Tokyo Marui mp5 has just been upgraded to 340 fps with new spring piston gearbox etc. However since the upgrade my 8.4v 3600 mah NI-MIH battery does not have enough oomph to fire the gun. But if I remove the extended cable from the gearbox (in the solid stock) which has the 15 amp inline fuse, and plug the battery direct into the gearbox it works fine. Although I did just burn out the motor doing this (motor was ancient) and a marui eg1000 for the record. Please help, ive got a new eg1000 motor and need to get this resolved and working before friday! Can I lower the ampage of the fuse to allow more current through! I'm at a loss!!!
-
Right my Tokyo Marui mp5 has just been upgraded to 340 fps with new spring piston gearbox etc. However since the upgrade my 8.4v 3600 mah NI-MIH battery does not have enough oomph to fire the gun. But if I remove the extended cable from the gearbox (in the solid stock) which has the 15 amp inline fuse, and plug the battery direct into the gearbox it works fine. Although I did just burn out the motor doing this (motor was ancient) and a marui eg1000 for the record. Please help, ive got a new eg1000 motor and need to get this resolved and working before friday! Can I lower the ampage of the fuse to allow more current through! I'm at a loss!!!