Looking to get rid of this rifle, for sale or swap, all offers welcome.
Very few stock parts left, however upgraded parts have very little wear due to low use. (See parts list bellow).

 

Included in this bundle is the rifle, 2 short Ares PMAG's and 1 Tan hicap mag, - Also a second upper gearbox, currently set up as a DMR ready setup, however this can be rebuilt VERY easily to anything else, or simply spares.

 

If you have any questions not answered here, please shout!

 

Regards,

Jester

 

 

Explanation of rails and front end:

 

So, you may have noticed it has no side or bottom rails.
You are correct, I shaved them off as my plan was to create an MLOK rail or something similar to the TM DELTA rails.
I was unable to finish this project due to work and life catching up.
The rails on the sides can be cut to MLOK size easily, however the bottom due to the internal dimensions can only have the TM DELTA style unless milled out.

 

The suppressor front end thing, this was another project I finished, it is a piece of steel pipe I cut, welded and painted and placed in the front to act as an integrated suppressor.

The suppressor does not contain an inner barrel and has some foam in (makes a nice thump noise at distance).

It is only held in with black silicone sealant, so you can remove it with some small effort, once done you can take out the barrel spacer, turn it around and you have the original working look again.

 

 

 

 

Parts list:

 

ZCI 300mm tightbore barrel

Maple leaf 50 degree hop rubber
ICS metal hop unit
 

ZCI 13:1 gearset w/ bearing tappet pin on sector gear - Gears have been short stroked 1 tooth to drop fps slightly.

SHS high torque motor, replaced armature for stronger one, estimated 22TPA.

Rewired with less resistant wiring

Element trigger switch assembly

GATE Nano MOSFET (wired to both contacts)

Setup can run a 7.4v LiPo, would not run an 11.1v without further mods as 11.1 makes it double fire on semi.
 

Upper A:  -  330fps

G&P white piston with 2 metal release teeth 

Stock cylinder head w/ AoE correction foam

Stock nozzle

Stock tappet plate + upgraded tappet spring

Slightly cut M120 spring

Metal spring guide

Stock cylinder

 

Upper B:  -  ~430fps

Lonex Red piston  NEEDS RELEASE TOOTH REMOVED BEFORE USE

SHS metal bearing piston head

ASG Ultimate cylinder head w/ Aoe Correction foam

Stock nozzle

Stock tappet plate w/ upgrade tappet spring

Guarder M130 spring

Metal spring guide

SHS heat sync Cylinder (full seal)