Front flaps/placards for any PC along the lines of the Mayflower APC or WAS RPC with appropriate places for 1" QASM buckles and loop velcro on the belly area. Had these made up by Dead Coyote Tactical Nylon a few years back when I couldn't find anything else that fitted an MP2/KYWI type insert but was sized for a plate carrier without overhanging the sides of the the front plate the way the D3CR did.

Got one in MC here for sale (RG is sold), all in 500D cordura with all the mil-spec webbing and thread etc you'd expect from a high quality gear brand - all come with blanking plates on the rear. All been used in 1 skirmish each, no wear other than a couple of tiny BB marks which can probably be washed right out. The pouches are a tad deep for the MP2s so I've bulked out the bases with some foam to get the best possible function and retention, but as with ESSTAC pouches and other equivalents retention is bloody brilliant. Holds mags extremely securely, but access for reloads is instant when required.

Price is per placard, P&P included. If you want a set of 3 x MP2s to go inside price will be £26 all in per placard. If you don't want the MP2s just punch a hole in the front of each pouch with a soldering iron and you can easily run bungee over the top of each mag for a triple shingle effect.