Some of you might have seen my previous post on the 1911 grips.
I have also given a few sets away and had some great feedback ! Thanks
Through the feedback I have learned a lot and have made numerous changed to how I make the grips.
I will post about this later.
Anyway, I need your help
I would like to make the grips so thst they are compatibly on as many models as possible.
I have found the raised area of the screw hole on the TM 1911 quite high and on the KWA1911 low as seen in the photos.
If I make a set on the TM it will also fit the KWA, but if I make it on the KWA, it will not fit the TM.
I therefore have to make them fit on the make that had the highest raised area.
This is what I am asking.
Please submit a photo of this area of your gun.
Not TM or KWA - I have them.
Also measure the distance between the centres of the 2 holes.
I find them to be 78mm on both the TM and KWA
Thanks for any help
I am working on quite a few sets of grips and they look very cool indeed.
I am also now supplying a care kit with the grips - oil, lint free cloth